DPRG
DPRG List  



[DPRG] Hamamatsu P5587

Subject: [DPRG] Hamamatsu P5587
From: Robert L. Jordan rljordan at airmail.net
Date: Tue Aug 29 08:08:21 CDT 2000

I custom drilled a very small PCB and soldered wires and chip to it. Then drilled 2 holes for mounting.
Chip holes and wire holes were different so I would not break the leads. Also, you might want to use small flexible wires
Robert L. Jordan

-----Original Message-----
>From:	Sanjay Agrawal [SMTP:sanjaya at home.com]
Sent:	Monday, August 28, 2000 10:31 PM
To:	DPRG
Subject:	[DPRG] Hamamatsu P5587

I have yet another question.  I want to add Hamamatsu P5587s to my servo
motors to act as encoders, as outlined in the Mobile Robots book.  But
the leads are *very* delicate and break easily.  I'm also afraid that
the heat from soldering thicker leads onto them will result in damage to
the circuitry.  There are 2 pins on one side, and 3 on the other, so I
can't mount it in a socket.  In the book, the picture shows wires
directly connected to the pins, but it's unclear how.  What have you
found is the best way to connect/mount a P5587?

_______________________________________________
DPRGlist mailing list
DPRGlist at dprg.org
http://nimon.ncc.com/mailman/listinfo/dprglist



More information about the DPRG mailing list