DPRG
DPRG List  



[DPRG] Re: H Bridges

Subject: [DPRG] Re: H Bridges
From: Rodent daweasel at swbell.net
Date: Fri Oct 12 12:57:34 CDT 2001

If you are handy you can build a decent H-bridge alot cheaper. There are
plans all over the internet. The Robot Store H-bridge is rather expensive,
especially if you need another controller and stuff to go with it.

The Pittman motors draw 2.8 amps each or total?

----- Original Message -----

> I have two of the Pittman GM8712 motors that Tanners was selling.  They
draw
> about 2.8 amps.   I want to run them with either a BS2 or HC11.
>
> The Robot Store has a Maxi Dual H-bridge for up to 40 volts and 10 amps
(pg
> 41).  Would this be suitable?   I assume I'll need the Serial Motor
Interface
> Kit and a heat sink.
>
> These are kits.  Are there any good, assembled H-bridges?




More information about the DPRG mailing list