DPRG List

 [DPRG] Help needed to fix line follower's oscillations Message index sorted by: [ date ] [ thread ] [ subject ] [ author ] Previous message: [DPRG] Help needed to fix line follower's oscillations Next message: [DPRG] Help needed to fix line follower's oscillations Subject: [DPRG] Help needed to fix line follower's oscillations From: Ralph Tenny rten at metronet.com Date: Tue Jun 11 17:26:26 CDT 2002 ```Clay: What is the response time of the sense-react-correction loop? It sounds as if the response loop is simply not fast enough. It sounds crazy, running >from a micro, and I don't know how to test for this in your system. But, if the actual steering correction takes too long you could get this error. Ralph On Tue, 11 Jun 2002, Clay Timmons wrote: > > > I'm working on a line following robot and having trouble with > the steering. The problem I'm having is getting the robot > to track a straight line at higher speeds. On a straight line > the robot corrects a bit to the left and overshoots > the line a tiny amount then it corrects to the right and > overshoots a bit more, then left, then right, etc. each time > with larger overshoot until it loses the line. Looks sort of > like a sine wave with increasing amplitude. > > I expect the left right left right ... oscillation but I don't > understand why the overshoot is growing and growing. > > My steering algorithm is simple. The robot has 6 line sensors, > 3 on the left and 3 on the right. The microcontroller sets the > steering angle based on where the line is at. Basically it's > a look up table with 6 entries. > > Any idea how to add dampening to the steering algorithm? > > PID type control? My current system is proportional only > and I may need the D term. Is this really possible to take > the derivative of something that only has 3 values? > > PID type control? I've tried adjusting the gain of my system. > I used a knob input on the microcontroller to set the steering lookup > table before each run. If I turn the gain down the system is more > stable and oscillates slowly without increasing amplitude. With > the gain turned up the robot oscillations increase as described. > The problem is that if I turn the gain down so low that it tracks > a straight line it won't make the turns. How can I get it to be > responsive to the turns yet stable on the straights? > > > Speed sensitive steering? I'm also wondering if my steering response > needs to be speed sensitive. I'm thinking of how a human would drive > a car. Would the same steering corrections for 5 MPH be appropriate > at 60 MPH? I've done all my testing at about 1/2 throttle on the > robot but my goal is to be able to follow the line at any speed. > > > Any help is really appreciated. I've been stuck on this problem > for days and my brain is getting fried. > > > > > > _______________________________________________ > DPRGlist mailing list > DPRGlist at dprg.org > http://nimon.ncc.com/mailman/listinfo/dprglist > ``` Previous message: [DPRG] Help needed to fix line follower's oscillations Next message: [DPRG] Help needed to fix line follower's oscillations Message index sorted by: [ date ] [ thread ] [ subject ] [ author ] More information about the DPRG mailing list