DPRG
DPRG List  



[DPRG] ATmega64 and JTAG problems.

Subject: [DPRG] ATmega64 and JTAG problems.
From: Kipton Moravec kip at kdream.com
Date: Sun Jun 19 10:06:41 CDT 2005

I am running Studio 4.11 Build 403

I get the Red and Green LED on, on the JTAG interface. The third LED is
off.

I try to connect to the JTAG and I get a Connect Failed Pop-up window.

It lets me choose the device.

It works with the ISP but not with the JTAG. I am plugging them into the
same serial cable.

Weird.

Kip

On Sun, 2005-06-19 at 10:57 -0400, DeltaGraph at aol.com wrote:
> Kip,
> OK, I got curious about the JTAG thing.
> 
> I am running studio 4.07 (which I know I need to upgrade).
> You probably did see note that JTAG module and target needs to be
> powered before starting studio for auto detect to work.
> 
> I just started up without power to my target controller board and got
> message
> "The OCD JTAG adapter was detected, but there is no target power..."
> when I clicked on the programmer icon (chip with AVR printed on it).
> 
> I powered target. then got message that device did not return valid
> JTAG ID
> 
> Told me I need to make sure JTAG enabled (fuse set).
> Now, I remember fuse not set.
> So I grabbed serial programmer (SDK-500) and set the fuse then
> reconnected JTAG and it works.
> 
> Just programmed device using JTAG
> Pretty fast -- as advertised.
> 
> No time to play with debug functions ...
> 
> Ron
> 
> 
> 
> 
> 
> 
-- 
Kipton Moravec <kip at kdream.com>


More information about the DPRG mailing list